Watch Restoration Guide: Protecting Your Dead Fake Rolex Watches
The reason why the Fake Rolex Watches mechanical watch stops”Basically,many people who work in the office will occasionally stop the watch,then this is because the kinetic energy of the watch is insufficient,because if it is not worn for a long time or the wearer does little exercise,it will The watch stops due to insufficient swing.Next,I will use Rolex as an example to talk about why the Rolex watch stops and the solution,Protect your fake Rolex watch.
1.Lack of motivation
The automatic mechanical watch only needs to move the arm to wind it,but if your exercise intensity is reduced,or your Fake Rolex Watches is not worn for too long,the watch may be prohibited by the error of the mechanical watch or stop directly due to insufficient power..At this time,put on the Rolex watch again and do normal activities.
2.The wearing time is too short
If the Fake Rolex mechanical watch is really caused by too little exercise,don’t worry,just take off the watch before going to bed and shake it horizontally for about 2 minutes.Of course,you can also shake it for 4 minutes,so that it will last longer.The watch has a winding function and can also be wound manually,and it can be wound clockwise by itself.In order for your favorite watch to go longer,it is recommended to wear it on your wrist for at least 6 to 8 hours a day.
3.Hairspring failure
If the reason for the lack of power of the Rolex mechanical watch is not the two mentioned above,then it may be the hairspring.If you usually exercise too much,the mainspring will be tighter,and the mainspring may be broken.If the power is insufficient due to winding,it is usually between 10 o’clock and 12 o’clock at night.At this time,the needle wheel of the”calendar function table”will start to push the calendar dial.If the power is insufficient and no one is pulling it,it will easily stop.Do not set back during this time.Many mechanical watches have plastic parts.If you accidentally break a gear,you’ll either get stuck at this time of day or stop jumping on a fixed date.So ah,it caused the mechanical watch to stop stealthily.
4.Collision failure
The spare parts of a Rolex mechanical watch are all precise and small.If you accidentally bump into them,or bump into them with a healthy body.This is easy to cause the movement parts to fall off or be directly broken.
The above is about why Fake Rolex Watches stop?For the full content of the reasons why Rolex watches stopped,if you want to buy watches,you can pay attention to www.replicawatches1st.com